联 系 人:段煜

电  话:15214379366

手  机:16602115336

地  址:上海市崇明县长兴镇潘园公路1800号2号楼9703室(上海泰和经济发展区)

邮  编:201913

传  真:021-80186165

邮  箱:435399850@qq.com

阿仪网商铺:http://www.app17.com/c110001/

手机网站:m.jwswbio.com

技术文章

人CD8分子(CD8)ELISA检测试剂盒2022资料已更新

点击次数:329   发布时间:2022/9/14 11:45:46

 本试剂盒只能用于科学研究,不得用于医学诊断

CD8分子CD8ELISA检测试剂盒

使用说明书

检测原理

试剂盒采用双抗体夹心法酶联免疫吸附试验(ELISA)。往预先包被CD8分子CD8)捕获抗体的包被微孔中,依次加入标本、标准品、HRP标记的检测抗体,经过温育并di洗涤。用底物TMB显色,TMB在过氧化物酶的催化下转化成蓝色,并在酸的作用下转化成*终的黄色。颜色的深浅和样品中的CD8分子CD8)呈正相关。用酶标仪在450nm 波长下测定吸光度(OD 值),计算样品浓度。

试剂盒组成

名称

96孔配置

48孔配置

备注

微孔酶标板

12孔×8条

12孔×4条

标准品

0.3mL

0.3mL

样本稀释液

6mL

3mL

检测抗体-HRP

10mL

5mL

20×洗涤缓冲液

25mL

15mL

按说明书进行稀释

底物A

6mL

3mL

底物B

6mL

3mL

终止液

6mL

3mL

封板膜

2张

2张

说明书

1份

1份

自封袋

1个

1个

注:标准品浓度依次为:4020、10、5、2.5、0 ng/mL.

试剂盒照片

试剂的准备

 20×洗涤缓冲液的稀释:蒸馏水按1:20稀释,即1份的20×洗涤缓冲液加19份的蒸馏水。

样品收集、处理及保存方法

1.  血清:使用不含热原和内毒素的试管,操作过程中避免任何细胞刺激,收集血液后,3000转离心10分钟将血清和红细胞迅速小心地分离。

2.  血浆:EDTA、柠檬酸盐或肝素抗凝。3000转离心30分钟取上清。

3.  细胞上清液:3000转离心10分钟去除颗粒和聚合物。

4.  组织匀浆:将组织加入适量生理盐水捣碎。3000转离心10分钟取上清。

5.  保存:如果样本收集后不及时检测,请按一次用量分装,冻存于-20℃,避免反复冻融,在室温下解冻并确保样品均匀地充分解冻。

试剂盒性能

1.  准确性:标准品线性回归与预期浓度相关系数R值,大于等于0.9900。

2.  灵敏度:*di检测浓度小于0.1 ng/mL

3.  特异性:不与其它可溶性结构类似物交叉反应。

4.  重复性:板内变异系数小于10%、板间变异系数小于15%。

5.  贮藏:2-8℃,避光防潮保存。

6.  有效期:6个月

免责声明

1.   试剂盒仅供研究使用,不得用于临床实验或人体实验,否则所产生的一切后果,由实验者承担,本公司概不负责。

2.   严格按照说明书操作,实验者违反说明书操作,后果由实验者承担。

 

自备物品

1. 酶标仪(450nm)

2. 高精度加样器及枪头:0.5-10uL、2-20uL、20-200uL、200-1000uL

3. 37℃恒温箱

操作注意事项

1.  试剂盒保存在2-8℃,使用前室温平衡20分钟。从冰箱取出的浓缩洗涤液会有结晶,这属于正常现象,水浴加热使结晶quan溶解后再使用。

2.  实验中不用的板条应立即放回自封袋中,密封(低温干燥)保存。

3.  预处理后的样本无需稀释,直接取10μL加样即可。

4.  严格按照说明书中标明的时间、加液量及顺序进行温育操作。

5.  所有液体组分使用前充分摇匀。

洗板方法

1.  手工洗板:甩尽孔内液体,每孔加满洗涤液,静置1min后甩尽孔内液体,在吸水纸上拍干,如此洗板5次。

2.  自动洗板机:每孔注入洗液350μL,浸泡1min,洗板5次。

操作步骤

1.  从室温平衡20min后的铝箔袋中取出所需板条,剩余板条用自封袋密封放回4℃。

2.  设置标准品孔和样本孔,标准品孔各加不同浓度的标准品50μL;

3.  待测样本孔先加待测样本10μL,再加样本稀释液40μL;

4.  随后标准品孔和样本孔中每孔加入辣根过氧化物酶(HRP)标记的检测抗体100μL,用封板膜封住反应孔,37℃水浴锅或恒温箱温育60min。

5.  弃去液体,吸水纸上拍干,每孔加满洗涤液,静置1min,甩去洗涤液,吸水纸上拍干,如此重复洗板5次(也可用洗板机洗板)。

6.  每孔加入底物A、B各50μL,37℃避光孵育15min。

7.  每孔加入终止液50μL,15min内,在450nm波长处测定各孔的OD值。

结果判断

 绘制标准曲线:在Excel工作表中,以标准品浓度作横坐标,对应OD值作纵坐标,绘制出标准品线性回归曲线,按曲线方程计算各样本浓度值。 


FOR RESEARCH USE ONLY. 

NOT FOR USE IN DIAGNOSTIC PROCEDURES.

 

Human Cluster of differentiation 8 (CD8) ELISA Kit instruction

 

Intended use

This CD8 ELISA kit is intended Laboratory for Research use only and is not for use in diagnostic or therapeutic procedures. The Stop Solution changes the color from blue to yellow and the intensity of the color is measured at 450 nm using a spectrophotometer. In order to measure the concentration of CD8 in the sample, this CD8 ELISA Kit includes a set of calibration standards. The calibration standards are assayed at the same time as the samples and allow the operator to produce a standard curve of Optical Density versus CD8 concentration. The concentration of CD8 in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Sample collection and storages

Serum - Use a serum separator tube and allow samples to clot for 30 minutes before centrifugation for 10 minutes at approximately 3000×g. Remove serum and assay immediately or aliquot and store samples at -20℃ or -80℃.Avoid repeated freeze-thaw cycles

Plasma - Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples for 30 minutes at 3000×g at 2-8℃ within 30 minutes of collection. Store samples at -20℃or -80℃. Avoid repeated freeze-thaw cycles.

Cell culture supernates and other biological fluids - Remove particulates by centrifugation and assay immediately or aliquot and store samples at -20℃or -80℃. Avoid repeated freeze-thaw cycles.

Note:  The samples shoule be centrifugated dequately and no hemolysis or granule was allowed.

Materials required but not supplied

1.  Standard microplate reader(450nm)

2.  Precision pipettes and Disposable pipette tips.

3.  37 ℃ incubator

Precautions

1.  Do not substitute reagents from one kit to another. Standard, conjugate and microplates are matched for optimal performance. Use only the reagents supplied by manufacturer.

2.  Do not remove microplate from the storage bag until needed. Unused strips should be stored at 2-8°C in their pouch with the desiccant provided.

3.  Mix all reagents before using.

Remove all kit reagents from refrigerator and allow them to reach room temperature ( 20-25°C)

Materials supplied

Name

96 determinations

48 determinations

Microelisa stripplate

12*8strips

12*4strips

Standard

0.3ml

0.3ml

Sample diluent

6.0ml

3.0ml

HRP-Conjugate reagent

10.0ml

5.0ml

20X Wash solution

25ml

15ml

Chromogen Solution A

6.0ml

3.0ml

Chromogen Solution B

6.0ml

3.0ml

Stop Solution

6.0ml

3.0ml

Closure plate membrane

2

2

User manual

1

1

Sealed bags

1

1

Note: Standard concentration was followed by:

40201052.50 ng/mL.

Reagent preparation

20×wash solution:Dilute with Distilled or deionized water 1:20.

Assay procedure

1.  Prepare all reagents before starting assay procedure. It is recommended that all Standards and Samples be added in duplicate to the Microelisa Stripplate.

2.  Add standard: Set Standard wells, testing sample wells. Add standard 50μl to standard well.

3.  Add Sample: Add testing sample 10μl Then add sample diluent 40μl to testing sample well; Blank well doesnt add anyting.

4.  Add 10l of HRP-conjugate reagent to each well, cover with an adhesive strip and incubate for 60 minutes at 37°C. 

5.  Aspirate each well and wash, repeating the process four times for a total of five washes. Wash by filling each well with Wash Solution (400μl) using a squirt bottle, manifold dispenser or autowasher. Complete removal of liquid at each step is essential to good performance. After the last wash, remove any remaining Wash Solution by aspirating or decanting. Invert the plate and blot it against clean paper towels.

6.  Add chromogen solution A 50μl and chromogen solution B 50μl to each well. Gently mix and incubate for 15 minutes at 37°C. Protect from light.

7.  Add 50μl Stop Solution to each well. The color in the wells should change from blue to yellow. If the color in the wells is green or the color change does not


appear uniform, gently tap the plate to ensure thorough mixing.

8.  Read the Optical Density (O.D.) at 450 nm using a microtiter plate reader within 15 minutes.

Calculation of results

1. This standard curve is used to determine the amount in an unknown sample. The standard curve is generated by plotting the average O.D. (450 nm) obtained for each of the six standard concentrations on the vertical (Y) axis versus the corresponding concentration on the horizontal (X) axis.

2. First, calculate the mean O.D. value for each standard and sample. All O.D. values, are subtracted by the mean value of the zero standard before result interpretation. Construct the standard curve using graph paper or statistical software.

3. To determine the amount in each sample, first locate the O.D. value on the Y-axis and extend a horizontal line to the standard curve. At the point of intersection, draw a vertical line to the X-axis and read the corresponding concentration.

4. Any variation in operator, pipetting and washing technique, incubation time or temperature, and kit age can cause variation in result. Each user should obtain their own standard curve.

5. The sensitivity by this assay is 0.1 ng/mL.

6. Standard curve 

 

Storage:  2-8.

validity six months.

 

FOR RESEARCH USE ONLY; NOT FOR THERAPEUTIC OR DIAGNOSTIC APPLICATIONS! PLEASE READ THROUGH ENTIRE PROCEDURE BEFORE BEGINNING!

原创作者:上海极威生物科技有限公司

首 页| 公司介绍| 产品展示| 公司新闻| 荣誉证书| 资料下载| 技术文章| 联系我们| 客户留言

阿仪网 设计制作,未经允许翻录必究.   联系人:段煜 联系电话:15214379366 ICP备案号:沪ICP备15046135号-2 总访问量:3734860 管理登录

主营产品:ELISA试剂盒,标准品,细胞株,抗体,生物试剂,化学试剂,培养基,血清,实验耗材,ABcam抗体,CST抗体,Santa抗体,ATCC细胞株,人elisa检测试剂盒,小鼠elisa试剂盒,大鼠elisa试剂盒,牛elisa试剂盒,羊elisa试剂盒,猪elisa试剂盒,犬elisa试剂盒,植植物elisa试剂盒,elisa 检测试剂盒报价,试剂盒批发,免费代测elisa 试剂盒,细胞株供应商,实验外包

扫一扫,关注我们

9

阿仪网推荐收藏该企业网站

客户服务热线:

15214379366

16602115336

工作时间

8:30-18:30